Water Injection Method

water injection

Turn the hot water bottle power socket up, lay it flat on the table, and open the filling plug.

Use the small funnel in the attachment to open the bottom baffle of the water injection port, and make sure that the small funnel is inserted into the bottom.

Then remove the small funnel and screw it on the beverage bottle with matching thread. A one-time injection is enough. (Don't change the water again)

The amount of water injected corresponds to the product you purchased.

exhaust

One: After the water injection is completed, exhaust air, screw the water injection port to the highest point, and then slowly lower it. When the liquid overflows from the water injection port, plug the water injection port with a small plug. (The top of the small plug and the top of the water injection port should be flat)

Two: Use a dry cloth or towel to carefully dry the water marks on the charging stand and the bag body to ensure that the surface of the product is dry, then you can start charging.